-->
Our Process Gallery Why Choose Us

●

Now Booking Michigan Fence Builds & Gate Installations • Free On-Site Estimates

Metro Detroit & Ann Arbor

FENCE REPAIR GUIDE

|

Fix It Right

How to Fix a Leaning Fence Post

A leaning post is a symptom. In Michigan it is usually frost heave, rot at grade or a footing that was too shallow from day one. Find the cause first, because the fix for a rotted wood post is different from the fix for a sound post in a loose hole.

Diagnose in Five Minutes

Brace vs. Mender vs. Reset

Repair Costs Per Post

42″ Frost-Line Fix

DIRECT DISPATCH PHONE

Get Your Free Estimate

Quick response guaranteed within 24 hours

Online Booking Open

🔒 Your contact info is strictly confidential. We never sell your data or spam you.

WHY POSTS LEAN

The Four Usual Causes

Push the top of the post, then dig two inches down at the base. What you find tells you which of these you are dealing with.

Frost Heave

Michigan frost reaches about 42 inches. Posts set at 24 to 30 inches get lifted a little each winter until they tip.

Most common in Metro Detroit

Rot at Grade

Wood posts rot where soil, air and water meet. If a screwdriver sinks in at ground level, the post is done.

Replace, do not brace

Wind Load

Solid privacy fences act like sails. A long run with one weak post will fold at that post first in a storm.

Watch the windward side

Poor Footing

Concrete collars that bell out at the top, no gravel base, or soil that holds water all loosen posts over time.

Shape and drainage matter

CHOOSING A FIX

Brace, Mender or Full Reset: Which Repair Fits

If the post is solid wood and the concrete is intact but the whole footing rocks, the lean is a soil problem. You can dig around the footing, push the post plumb, brace it and backfill with compacted gravel or new concrete. A steel post repair stake driven beside a sound post is another quick fix, but it only holds if the wood above grade is healthy.

If the post is rotted, snapped or heaved more than a couple of inches, replace it. That means freeing the panels, breaking out the old footing, and setting a new post 42 inches deep in concrete so it sits below the frost line. Our post replacement service does exactly that and keeps the existing panels when they are sound. When several posts in a row are leaning, the fence was usually set too shallow and a section rebuild is the honest answer.

TYPICAL REPAIR COST

DIY Cost

Pro Cost

Re-Tamp & Brace

Sound post, loose soil

$10–$30

$100–$200

Steel Repair Stake

Rot below grade only

$25–$60

$150–$300

Reset in Concrete

Same post, new footing

$30–$60

$200–$400

Replace Wood Post

New post, 42″ deep

$60–$120

$250–$550

Gate Post Rebuild

Steel-stiffened

Not advised

$400–$900

HOW TO REPLACE A LEANING POST

Straightening a Fence Post in Three Steps

This is the full-replacement method for a rotted or heaved wood post. Plan on half a day per post if you do it yourself.

01

Step 1

Free & Support the Panels

Brace the panels on both sides with 2x4s, then unscrew or cut the rails from the leaning post so it can come out.

Call Miss Dig 811 first

Temporary 2x4 braces

Mark rail heights

HEAVY LIFTING

02

Step 2

Remove the Old Footing

Dig beside the footing, rock it loose and lever it out. A bar and a farm jack make this possible without breaking the neighbors' panels.

Dig on one side only

Jack or lever out the plug

Widen hole to 10–12″

03

Step 3

Set the New Post Deep

Add 4 to 6 inches of gravel, set the post plumb at 42 inches deep, fill with concrete crowned away from the wood and reattach rails after it cures.

Gravel base for drainage

Plumb on two faces

Cure 24–48 hours

Gate Not Latching?

A leaning gate post is the usual reason. We rebuild gate posts with steel stiffeners so they stay plumb.

PREVENTION

Keep Your Posts Standing Straight

Most of these cost little or nothing and add years to a fence.

Go Below Frost

Any new or replacement post should sit at 42 inches in Metro Detroit. Shallower posts will move again.

Shed Water

Crown the concrete so water runs away from the post, and keep mulch and soil from piling against the wood.

Use Ground-Contact Lumber

Posts need ground-contact pressure treatment, not above-ground grade. The tag on the end tells you which.

Trim Vines and Shrubs

Vines hold moisture and add weight and wind load. Keep growth off the fence line.

Fix One Early

One leaning post pulls on its neighbors. Repairing it this season can save the next two posts.

Check After Storms

Walk the line after big wind. A slight lean is a quick reset; a fallen section is a bigger bill.

Mind the Gate Side

Gate posts lean first because they carry swinging weight. Check them each spring and adjust hinges early.

Avoid Sprinkler Soak

Aim sprinkler heads away from posts. Constant wetting softens soil and speeds rot at grade.

Need More Than One Post Fixed?

See how we repair, stabilize and rebuild fences across Wayne, Oakland and Macomb.

FREQUENTLY ASKED QUESTIONS

Leaning Fence Post Questions

Quick answers on causes, fixes and price.

How much does it cost to fix a leaning fence post?

A professional reset of a sound post usually runs $150 to $400, and a full wood post replacement in concrete runs $250 to $550. Gate posts, access issues and vinyl or aluminum posts cost more.

Can I straighten a fence post without removing it?

Yes, if the post is not rotted. Dig around the footing, push it plumb, brace it and backfill with compacted gravel or concrete. If the wood is soft at grade, replace it instead.

Do fence post repair stakes work?

They work as a quick fix when the post is rotted only below ground and the wood above is solid. They do not fix frost heave or a shallow footing.

Why do my fence posts lean every spring?

Frost heave. Water in the soil freezes and expands, lifting posts that are not set below the 42-inch frost line. Resetting them deeper is the permanent fix.

Should I replace the whole fence if posts are leaning?

Not always. If boards and rails are sound and only a few posts lean, replacing posts is cheaper. If most posts are rotted or shallow, rebuilding is often the better value.

How do I fix a leaning vinyl or aluminum fence post?

Vinyl posts usually sit over a concrete footing and can be reset after the panels are released, and aluminum posts are reset in new concrete. Because the rails lock into routed holes, the work must keep panel spacing exact, so many owners hire it out.

FREE REPAIR ESTIMATE

Get Your Leaning Fence Fixed

We will diagnose the cause, tell you whether to repair or replace, and give a written price per post.

PREFER TO CALL DIRECTLY?

Speak directly with our estimating desk for quick questions or emergency repairs.

Posts reset 42″ below frost line

Existing panels reused when sound

Debris and old concrete hauled away

Get Your Free Estimate

Quick response guaranteed within 24 hours

Online Booking Open

🔒 Your contact info is strictly confidential. We never sell your data or spam you.